Dual Suppressor Slip-On Exhaust for '24+ RZR XP 1000 by Aftermarket Assassins

Dual Suppressor Slip-On Exhaust for '24+ RZR XP 1000 by Aftermarket AssassinsSKU: 110 1023 Fits all 2024+ RZR XP 1000 models **Requires trimming rear plastic exhaust cover** **Does NOT fit 2014 23 RZR XP 1000 models** This stainless steel AA slip on exhaust is just what your machine needs! We set out to produce an exhaust that adds power, looks great, and sounds great without being obnoxiously loud. With our dual muffler design, this exhaust sounds amazing with a nice deep tone but not significantly louder than the OEM

SKU: 110-1023

Fits all 2024+ RZR XP 1000 models - **Requires trimming rear plastic exhaust cover**  **Does NOT fit 2014-23 RZR XP 1000 models**

• This stainless steel AA slip-on exhaust is just what your machine needs!  We set out to produce an exhaust that adds power, looks great, and sounds great... without being obnoxiously loud.
• With our dual muffler design, this exhaust sounds amazing with a nice deep tone but not significantly louder than the OEM exhaust.   At idle, off idle and wide open throttle you will notice a bit more rumble but when cruising, this exhaust is quieter than the stock exhaust.  The deeper tone helps cover up some of the engine noise/drone.
• Gain RWHP!  In our initial testing, we could instantly feel the difference with this exhaust and saw a 100-200 RPM gain.  The dyno backed this up by showing us the gains and just how quickly they came on.  The best thing about this exhaust is the ability to run our Cruiser clutch setup and still see a power gain.  This is a big deal, as with the OEM exhaust you lose much more power with our Cruiser setup.  This exhaust really shines everywhere, especially in the mid-range.
• If you'd still like less sound, you can install our 1.5" Stealth Quiet Core.  Installing this core drops horsepower and sound back to factory levels with nearly the same note.
• Can use your OEM spark arrestor in this exhaust or purchase our spark arrestor.
  • ** Exhaust cannot be used with both the spark arrestor and 1.5" stealth core at the same time**
• Much better airflow which is needed to decrease heat (especially when tuned)
• Eliminates the stock catalytic converter which creates a ton of exhaust and motor heat
• +7-9 RWHP with our Level 2 ECU flash for proper fueling
• **Will NOT fit with most rear bumpers**
• Made at the AA Facility in the USA!
• Sharp corners and outlets designed to match the XP1K styling
• Hydroblasted finish with rust inhibitor (Yes, even stainless can still develop surface rust) - The stainless will bronze and matches the stock header very well
• Can be used with the factory tune or our Level 1 tune without issue, but will run even better and gain the most power with our Level 2 tune designed for this exhaust.
• See exhaust sound clip here:  https://youtu.be/adnazFIiaKg

CB 2/5/25